Cabinets - HOME BAR PLANS, rzemiosło artystyczne, Projekty - stolarstwo
[ Pobierz całość w formacie PDF ]
HOME BAR PLANS
.
Attach Drawer Slides to Cleats
If you will be adding drawers to your bar, attach six drawer slides to cleats as
shown above. Remember, three must have the roller on the right and three must
have the roller on the left. The lowest part of the drawer slide must be flush with
the bottom of the cleat. The roller section must protrude past the end of the cleats
by 3/4" (the thickness of the trim).
Attach Drawer Slides Left Side and Divider
Attach three cleats with drawer slides to the left side as shown above. Attach two
cleats with drawer slides to left divider panel as shown above. Note: The bottom
cleat and drawer slide for the left divider is attached to the bottom with pocket
holes later. It will then provide a way to attach the left divider to the bottom.
Attach Drawer Slides for Wine Racks
If you will be including wine racks, in your bar, attach the drawer slides to the
divider panels as shown. Note: the drawer slides for the wine racks do
NOT
protrude 3/4" past the edge of the divider panels. This is because the wine rack
fronts will be flush with the opening while the drawer fronts will be on the
outside of the opening.
Attach Cleats to the Ends of the Bottom
Attach two cleats to the ends of the bottom surface of the bottom plate with
pocket hole screws as shown.
Attach Cleats to Middle of Bottom
Attach a cleat with a drawer slide mounted to the top surface of the bottom plate
as shown. Attach a cleat with no drawer slide as shown. Pocket holes sides should
be placed 16" from the ends with pocket hole sides facing each other as shown.
(These cleats are used for mounting the vertical panels to the bottom surface.)
Attach Vertical Dividers
Attach the vertical dividers to the cleats as shown. Attach the front cleat between
the panels as shown with pocket hole screws. Oops! I forgot to draw the drawer
slides on this drawing. They would already be in place at this point. Jujst try to
picutre them already mounted.
Attach the Kick Panel
[ Pobierz całość w formacie PDF ]